how to wire a 4 pin wires to normal dc 12v

Learning how to wire a 4 pin DC 12V connector can be tricky, but with the right tools and resources it can be done quickly and effectively. With some basic knowledge of electrical wiring and components, anyone can successfully wire a 4 pin DC 12V connector in no time.

The first step is to determine the exact make, model and specifications of the intended connector. Be sure to check the manufacturer’s instructions for any particular requirements or warnings that may apply. Once you’ve confirmed the correct specification, you’re ready to begin wiring. Start by stripping away enough cable insulation to expose the four wires inside. Identify each of the four wires: usually two are black and two are red, although you may also have green, yellow or other colors. Red wires typically indicate positive leads while the black wires indicate negative leads.

Next, locate the two pins on the 4 pin DC 12V connector that match the two positive leads. Twist the ends of each of the two positive wires together and then insert them into the two pins on the connector. Make sure they are snugly secured, and then crimp the ends of the wires with a soldering gun or similar device. Finally, repeat this process with the two black negative wires until they’re securely attached to the corresponding two pins on the connector. And there you have it — you’ve successfully wired your 4 pin DC 12V connector!

Splitter Cables For Led Strip Lights Ledsupply Blog